
You could
receive
a lifetime of relief from
the annoying tightness so
many athletes and weekend
warriors feel from
incessantly challenging
their bodies. Don't worry,
this isn't an infomercial. I
just want you to use a foam
roller for self-myofascial
release and deep tissue
massage.
Self-myofascial release
(SMR) on a foam roller is
possible thanks to the
principle known as
autogenic inhibition.
You've likely heard of the
Golgi Tendon Organ (GTO) at
some point in your training
career. The GTO is a
mechanoreceptor found at the
muscle-tendon junction; it's
highly sensitive to changes
in tension in the muscle.
When tension
increases to the point of
high risk of injury (i.e.
tendon rupture), the GTO
stimulates muscle spindles
to relax the muscle in
question. This reflex
relaxation is autogenic
inhibition. The GTO isn't
only useful in protecting us
from injuries, but it also
plays a role in making
proprioceptive neuromuscular
facilitation (PNF)
stretching techniques highly
effective.
The muscle
contraction that precedes
the passive stretch
stimulates the GTO, which in
turn causes relaxation that
facilitates this passive
stretch and allows for
greater range of motion.
With foam rolling, you can
simulate this muscle
tension, thus causing the
GTO to relax the muscle.
Essentially, you get many of
the benefits of stretching
and then some.
It's also
fairly well accepted that
muscles need to not only be
strong, but pliable as well.
Regardless of whether you're
a bodybuilder, strength
athlete, or ordinary weekend
warrior, it's important to
have strength and optimal
function through a full
range of motion. While
stretching will improve the
length
of the muscle, SMR and
massage work to adjust the
tone
of the muscle. Performing
one while ignoring the other
is like reading T-Nation but
never actually lifting
weights to put the info to
good use.
Traditional
stretching techniques simply
cause transient increases in
muscle length (assuming that
we don't exceed the "point
of no return" on the
stress-strain curve, which
will lead to unwanted
deformities). SMR on the
foam roller, on the other
hand, offers these benefits
and
breakdown of soft tissue
adhesions and scar tissue.
One mustn't
look any further than the
overwhelmingly positive
results numerous individuals
have had with Active Release
Techniques (ART) to
recognize the value of
eliminating adhesions and
scar tissue. Unfortunately,
from both a financial and
convenience standpoint, we
can't all expect to get ART
done on a frequent basis.
SMR on the
foam roller offers an
effective, inexpensive, and
convenient way to both
reduce adhesion and scar
tissue accumulation and
eliminate what's already
present on a daily basis.
Just note that like
stretching, foam rolling
doesn't yield marked
improvements overnight;
you'll need to be diligent
and stick with it (although
you'll definitely notice
acute benefits).
Foam rollers
can play a valuable
role in correcting postural
afflictions. Get to work on
those tight muscles and
you'll definitely see
appreciable returns on your
efforts! So
let's get started!
These
techniques are actually very
simple to learn. Basically,
you just use your body
weight to sandwich the
roller between the soft
tissue to be released and
the floor. Roll at a slow
pace and actually stop and
bear down on the most tender
spots ("hot spots"). Once
the pain in these spots
diminishes, roll the other
areas.
In order to
increase the pressure on the
soft tissue, simply apply
more of your body weight to
the roller. The simplest way
to do this is by either
moving from working both
legs at once to one leg, or
by "stacking" one of your
legs on top of the other to
increase the tension.
As you get
more comfortable with SMR,
you'll really want to be
bearing down on the roller
with most (if not all) of
your body weight. As with
almost anything in the
training world, there's
considerable room for
experimentation, so you'll
definitely want to play
around with the roller to
see what works best for you.
Be careful to avoid bony
prominences, though. (Insert
your own joke here.)
One other
technique we’ve found to be
beneficial is to work from
the proximal (nearest the
center of the body) to the
distal (away from the center
of the body) attachment of
the muscle. For instance,
instead of working your
quadriceps from top to
bottom all in one shot,
shorten your stroke a little
bit. Work the top half
first, and after it has
loosened up, move on to the
bottom half.
This is an
important strategy because
as you get closer to the
distal muscle-tendon
junction, there's a
concomitant increase in
tension. By working the top
half first, you decrease the
ensuing tension at the
bottom, essentially taking
care of the problem in
advance.
Note: Those
with circulatory problems
and chronic pain diseases
(e.g. fibromyalgia) should
NOT use foam rollers.
You'll want
to try these with the feet
turned in, out, and pointing
straight ahead to completely
work the entire hamstring
complex. Balance on your
hands with your hamstrings
resting on the roller, then
roll from the base of the
glutes to the knee. To
increase loading, you can
stack one leg on top of the
other.
Balance on your forearms
with the top of one thigh on
the roller. Roll from the
upper thigh into the hip.
Try this with the femur both
internally and externally
rotated. To do so, just
shift the position of the
contralateral pelvis. (In
the photo, Mike would want
to lift his right hip to
externally rotate the left
femur).
These are a little tricky,
so we've included pictures
from two different angles.
Without a doubt, this one
will be the most painful for
most of you.
In the
starting position, you'll be
lying on your side with the
roller positioned just below
your pelvis. From here,
you'll want to roll all the
way down the lateral aspect
of your thigh until you
reach the knee. Stack the
opposite leg on top to
increase loading.
Balance on
your forearms with the top
of one of your inner thighs
resting on the roller. From
this position, roll all the
way down to the adductor
tubercle (just above the
medial aspect of the knee)
to get the distal
attachments. You'll even get
a little vastus medialis
work in while you're there.
Watch out for your twig and
berries on this one, though!
This one is quite similar to
the hip flexor version;
you're just rolling further
down on the thigh. You can
perform this roll with
either one or two legs on
the roller.
Lie on your
side with the "meaty" part
of your lateral glutes (just
posterior to the head of the
femur) resting on the
roller. Balance on one elbow
with the same side leg on
the ground and roll that
lateral aspect of your
glutes from top to bottom.
Set up like you're going to
roll your hamstrings, but
sit on the roller instead.
Roll your rump. Enough said.
This, too, is
similar in positioning to
the hamstrings roll; you're
just rolling knee to ankle.
Try this with the toes up (dorsiflexion)
and down (plantarflexion).
Stack one leg on top of the
other to increase loading.
This is just
like the quad roll, but
you're working on your shins
instead.
This one is
similar to the TFL/ITB roll;
we're just working on the
lower leg now. Roll along
the lateral aspect of the
lower leg from the knee to
the ankle.
With your arms folded across
your chest, lie supine with
the roller positioned under
your midback. Elevate the
glutes and roll from the
base of the scapulae to the
top of the pelvis. You'll
want to emphasize one side
at a time with a slight lean
to one side.
With your
arms behind your head (not
pulling on the neck), lie
supine with roller
positioned in the middle of
your back; your glutes
should be on the ground.
Roll upward, reversing
direction when you reach the
level of the armpits. This
is an excellent intervention
for correcting kyphosis.
Lie on
your side with the same side
arm overhead. The roller
should be positioned at the
attachment of the lat on the
scapula in the starting
position. You'll want to
roll toward the attachment
on the humerus (roll toward
the armpit).
Start with
your body in the same
position as you would for
the latissimus dorsi. Now,
however, you'll want to
place the roller at the top
of your triceps (near your
armpit) and your noggin on
top of your arm to increase
the tension (and no, you
don’t have to be that geeky
kid from Jerry Maguire to
know the human head weighs 8
pounds!)
Lie prone with the roller
positioned at an angle
slightly to one side of the
sternum; the arm on this
side should be abducted to
about 135° (halfway between
completely overhead and
where it would be at the
completion of a lateral
raise). Roll toward the
humeral head (toward the
armpit).
Hopefully,
this article has been proof
enough that SMR on the foam
roller is an excellent
adjunct to your training,
diet, supplementation, and
restoration efforts.